Cyclops - Paralyser P275 - Immobiliser

Shipped in 2-3 Working Days
or 4 interest-free payments of $36.25
Learn more

Paralyser P275

Paralyser P275 Car Immobiliser

Installation available for an extra $250
(Installation available in Adelaide only)
Please contact us on 08 8371 5121 to book a time.


This Australian Standards approved immobiliser provides two circuits of automatic engine immobilisation operated by rolling code random encrypted remote control. The system may provide keyless entry and visual confirmation via the vehicles indicators. The system has a dash mounted high intensity red LED
Proudly Australian. Designed and engineered in Perth, Western Australia

Arming procedure while ignition is off
The system will arm immediately if the main button of a valid remote control is momentarily pressed, the doors will lock and all security functions will become active
•Disarming procedure
The system will disarm when the main button of a valid remote control is pressed
•Auto Arming
The car's engine is automatically immobilised 40 seconds after the engine has stopped. The auto-arming feature is disabled while the system is disarmed and the ignition switch is in the ON position

Dual Immobilisation Circuits
The system features two independent 30 Amp rated, normally open immobilisation circuits, which break engine critical signals in the vehicle. Starter motor, fuel pump, fuel injection, main ignition are commonly immobilised circuits
•Safety circuitry in case of power failure
System sources alternate power from ignition if main power is lost
•Third circuit of immobilisation (optional)
Additional immobilisation circuits can be added to conform with insurance company requirements
•Component protection against harsh road conditions
All relays are fully encapsulated to provide protection against dust and moisture

Rolling Code / Code Hopping
Rolling code encoder with over 18,000,000,000,000,000,000+ code combinations, transmitting via 433MHz PWM RF signal
•Controller Type
Uses two black ABS plastic remote controls with long life Lithium batteries
•Large system memory
Allows system to track three controllers
•Controller re-programming
Service technician can delete lost or stolen controllers from memory
•Compatible Remotes
This system comes standard with REM-111, but is compatible with these remote controls,
•Remote battery life
Two CR2016 Lithium batteries have a expected average life span of between 9 and 18 months (depending on usage). Battery manufacturer may vary due to availability of stock. See the GP battery manufacturer website.

Security wiring
All cables extending from the control module are black and same diameter. Identifying wire tags are removed by the installer during installation of the system
•Plug and play for service
Designed to allow easy access for service technicians. Plugs and sockets are located inside the main control module to protect against access by thieves
•Security housing
Connector plug is enclosed within module case to prevent access by thief
•Stealth wiring
Cutting any immobilisation wiring will still leave the car secure. Bypassing security is not possible by simply removing the system from the vehicle

Emergency Personal Identification Number (PIN) override
If the valid controller are lost, stolen or broken, the user by over-ride the system by enter the secret four digits via the ignition switch
•Alterable PIN
A factory programmed PIN comes standard with each system. It is recommended the owner of the system changes the PIN to a new, easily remembered number
•One shot override
Immobiliser always re-arms to protect vehicle. Re-enter PIN if vehicle needs to be driven after auto-arming has occurred
•PIN card
A record of the factory programmed override PIN is supplied on handy wallet sized card

Visual Output
Super bright red dash LED
This LED flashes to inform user when system is armed. The LED is mounted on the driver's side dash and is visible from outside the window
•Arm/Disarm confirmation
System flashes car indicators when arming or disarming

Central Locking
Locks and unlocks all doors
System can trigger factory central locking, aftermarket central locking or central locking relays

Current draw
•Wide Operating voltage
Operating voltage +9VDC to +15VDC
•Operating temperature
-20 degrees to +85 degrees for equipment designed to be installed within vehicle cabin
•Polarity protection
The system circuitry is design to protect itself against accidental battery polarity reversal. This can happen when replacing the vehicle battery
•Short circuit protection
The power supply wire to the system is protected against an internal fault within the system

Convenience Functions
Electric window closer
Provides signals used by electric window closers, system will close all electric windows when armed by remote control
Limitation(s)•Central locking pulse
Central locking output cannot be extended to trigger pneumatic central locking systems (Mercedes), Suggest using P355.

Manufacturers warranty on Control module Guarantees control module is free from manufacturing defects for 24 months from time of purchase
Manufacturers warranty on Remote controls
Guarantees remote controls are free from manufacturing defects for 12 months from time of purchase

Standards Compliance
Australian Standard for vehicle Immobilisers
AS/NZS 4601:1999 - Australian Standards website.
•Manufactured in ISO9001 facility
Built within world standard production facility
AS/NZS 4601 sundry standards of compliance (or parts thereof)
AS1939 - Degrees of protection provided by enclosures for electrical equipment (IP Codes)
AS3300 - Approval and test specification - General requirements for household and similar electrical appliances
AS/NZS3548 Limits and methods of measurement of radio disturbance characteristics of information technology equipment
AS/NZS3749 - Intruder alarm systems - Road vehicles
AS/NZS4268 - Radio equipment and systems - Short range devices
AS/NZS61000 - Electromagnetic compatibility (EMC)
NZS6300 - Approval and test specification - General requirements for household and similar electrical appliances
ISO7637 - Road vehicles - Electrical disturbance by conduction and coupling
IEC61000 - Electromagnetic compatibility (EMC)
ASTM B117 - Standard practice for operating salt spray (fog) apparatus

Write Your Own Review
You're reviewing:Cyclops - Paralyser P275 - Immobiliser
SSL Certificate
Copyright © 2018 Ministry of Bass. All rights reserved.