Cyclops - Paralyser P775B - Elite Car Alarm

A$335.00
Shipped in 2-3 Working Days
SKU
P775B

Paralyser P775B

Paralyser P775 Deluxe Upgrade Car Alarm

Installation available for an extra $300
(Installation available in Adelaide only)
Please contact us on 08 8371 5121 to book a time.

Introduction

This Australian Standards approved immobiliser alarm provides two circuits of engine immobilisation operated by rolling code random encrypted remote control, with inbuilt intelligent auto transponder disarm. Entry point protection of doors, boot and bonnet with an intelligent glass break sensor. Audible warning is achieved via a standard 115dB siren, visually via the vehicle indicators and via high intensity blue LED's dash and windscreen mounted. The system has status / diagnostic reporting and can provide keyless entry
Proudly Australian Designed and engineered in Perth, Western Australia

Operation
Arming procedure while ignition is off. The system will arm immediately if the main button of a valid remote control is momentarily pressed, the doors will lock and all security functions will become active.
Disarming procedure The system will disarm when the main button of a valid remote control is pressed
Auto Arming The car's engine is automatically immobilised 40 seconds after the engine has stopped. The auto-arming feature is disabled while the system is disarmed and the ignition switch is in the ON position
Available for light trucks. The P775 system is also available for light trucks which use a +24 Volts battery supply,

Immobilisation
Dual Immobilisation Circuits The system features two independent 30 Amp rated, normally open immobilisation circuits, which break engine critical signals in the vehicle. Starter motor, fuel pump, fuel injection, main ignition are commonly immobilised circuits
Safety circuitry in case of power failure. System sources alternate power from ignition if main power is lost
Third circuit of immobilisation (optional) Additional immobilisation circuits can be added to conform with insurance company requirements
Component protection against harsh road conditions. All relays are fully encapsulated to provide protection against dust and moisture

Controllers
Rolling Code / Code Hopping. Rolling code encoder with over 18,000,000,000,000,000,000+ code combinations, transmitting via 433MHz PWM RF signal
Controller Type. Uses REM-090T remote controls, see remote control details.
Remote control with transponder enhancements Allows the immobiliser to disarm automatically when ignition switch is turned on
Large system memory. Allows system to track ten controllers
Controller re-programming. Service technician can delete lost or stolen controllers from memory
Remote battery life Two CR2016 Lithium batteries have a expected average life span of between 9 and 18 months (depending on usage). Battery manufacturer may vary due to availability of stock.

Wiring
Security wiring
All cables extending from the control module are black and same diameter. Identifying wire tags are removed by the installer during installation of the system
Plug and play for service. Designed to allow easy access for service technicians. Plugs and sockets are located inside the main control module to protect against access by thieves
Security housing. Connector plug is enclosed within module case to prevent access by thief
Stealth wiring. Cutting any immobilisation wiring will still leave the car secure. Bypassing security is not possible by simply removing the system from the vehicle.

Override
Emergency Personal Identification Number (PIN) override. If the valid controller are lost, stolen or broken, the user by over-ride the system by enter the secret four digits via the ignition switch
Alterable PIN A factory programmed PIN comes standard with each system. It is recommended the owner of the system changes the PIN to a new, easily remembered number
One shot override Immobiliser always re-arms to protect vehicle. Re-enter PIN if vehicle needs to be driven after auto-arming has occurred
PIN car. A record of the factory programmed override PIN is supplied on handy wallet sized card

Visual Output
Super bright blue dash LED. This LED flashes to inform user when system is armed. The LED is mounted on the driver's side dash and is visible from outside the window
Super bright blue windscreen LED. This LED flashes to inform user when system is armed. The LED is mounted on the driver's side dash and is visible from outside the window
Arm/Disarm confirmation. System flashes car indicators when arming or disarming

Alarm illumination
System flashes car indicators when thief triggers alarm
Trigger diagnostics System will flash indicators to report the last triggered circuit

Audio Output
Standard sire. AS/NZS 3749.1:2003 Class B approved 115dB siren
Negative siren output Can be used to trigger car horn relay or siren
Arm/Disarm confirmation System sounds a siren when arming and disarming
Temporary arm/disarm chirp disable Momentarily press the second button of the remote control before pressing the main button, the siren will not chirp during that one operation

Intrusion Detection
Doors, bonnet and boot monitoring Triggers alarm system if intruder opens any protected entry point in vehicle
Audio glass breakage detection. Uses the sound of the breaking glass to trigger (not vibration) GBS-4XR.
Accepts plug-in Ultra-sonic sensor. Sensor produces a 40KHz sound wave and measures echo to detect intruder, ACC-001
Accepts plug-in single zone microwave sensor Sensor produces a microwave field to detect intruder,ACC-003.
Accepts plug-in dual zone microwave sensor
Sensor produces two microwave fields, exterior field to sound siren as warning, interior to trigger alarm in full, ACC-004.
Accepts plug-in single stage shock sensor Sensor measures vibration subjected to vehicle to detect intruder, SEN-002.
Accepts plug-in two stage shock sensor. Sensor measures two levels of shock, soft shock to sound siren as warning, heavy shock to trigger alarm in full, SEN-006
Compatible with tilt sensor Sensor measures vehicle angle with respect to earth, triggers if angle changes - no response to vibration SEN-004.

Central Locking
Locks and unlocks all doors System can trigger factory central locking, aftermarket central locking or central locking relays
Variable pulse time. Extend pulse length to drive pneumatic central locking systems (Mercedes)
Automatic re-locking. System will re-arm and re-lock doors if previously disarmed by remote control and doors remain closed
Anti-hijacking protection. System locks doors when ignition is turned on, unlocks when ignition is turned off
Dual stage unlock. Allows user to unlock driver's door before unlocking all other doors

Specifications
Current draw Wide Operating voltage. Operating voltage +9VDC to +15VDC
Operating temperature -20 degrees to +85 degrees for equipment designed to be installed within vehicle cabin
Operating temperature -20 degrees to +105 degrees for equipment designed to be installed inside engine compartment
Polarity protection. The system circuitry is design to protect itself against accidental battery polarity reversal. This can happen when replacing the vehicle battery
Independent indicator power fuse. System uses independent fuse to power indicators, ensures short circuit in indicator circuit does not affect system operation
Short circuit protection The power supply wire to the system is protected against an internal fault within the system.

Convenience Functions
Panic / Car Finder. Press and hold second button of remote control to cause siren to sound and indicators to flash
Electric window closer. Provides signals used by electric window closers, system will close all electric windows when armed by remote control
Courtesy light switch activation. System switches courtesy light on for 30 seconds or until ignition switch is turned on, when disarmed
Electronic boot release. Press and hold the secondary remote control button to activate boot release output. The indicators will flash four time each time the boot release signal is sent
Open door warning. Siren will chirp 8 times if door is open, and 6 times if bonnet is open; while system is being armed
Full diagnostic report Press and hold both buttons on a valid remote control to receive report of last three triggers
Low remote battery warning. System will flash indicators twice when ignition is turned on to report remote control battery is low

Warranty
Manufacturers warranty on Control module Guarantees control module is free from manufacturing defects for 24 months from time of purchase
Manufacturers warranty on Sundry items. Guarantees remote controls, siren and sundry items are free from manufacturing defects for 12 months from time of purchase

Standards Compliance
Australian Standard for vehicle Immobilisers AS/NZS 4601:1999
Australian Standard for Intruder alarm systems - Road vehicles - Performance requirements AS/NZS 3749.1:2003 Class B
Manufactured in ISO9001 facility Built within world standard production facility
AS/NZS 4601 sundry standards of compliance (or parts thereof)
AS1939 - Degrees of protection provided by enclosures for electrical equipment (IP Codes)
AS3300 - Approval and test specification - General requirements for household and similar electrical appliances
AS/NZS3548 Limits and methods of measurement of radio disturbance characteristics of information technology equipment
AS/NZS3749 - Intruder alarm systems - Road vehicles
AS/NZS4268 - Radio equipment and systems - Short range devices
AS/NZS61000 - Electromagnetic compatibility (EMC)
NZS6300 - Approval and test specification - General requirements for household and similar electrical appliances
ISO7637 - Road vehicles - Electrical disturbance by conduction and coupling
IEC61000 - Electromagnetic compatibility (EMC)
ASTM B117 - Standard practice for operating salt spray (fog) apparatus

Write Your Own Review
You're reviewing:Cyclops - Paralyser P775B - Elite Car Alarm
SSL Certificate
Copyright © 2016 Ministry of Bass. All rights reserved.