Cyclops - Paralyser P375B - Deluxe Car Alarm
Paralyser P375B Car Alarm
Installation available for an extra $450
(Installation available in Adelaide only)
Please contact us on 08 8371 5121 to book a time.
This Australian Standards approved immobiliser alarm provides two circuits of engine immobilisation operated by rolling code random encrypted remote control. Entry point protection of doors, boot and bonnet with an intelligent glass break sensor. Audible warning is achieved via a 115dB mini battery back up siren, visually via the vehicle indicators and via a dash mounted high intensity red LED. The system may provide keyless entry
Designed and engineered in Perth, Western Australia
Arming procedure while ignition is off
The system will arm immediately if the main button of a valid remote control is momentarily pressed, the doors will lock and all security functions will become active.
The system will disarm when the main button of a valid remote control is pressed
The car's engine is automatically immobilised 40 seconds after the engine has stopped. The auto-arming feature is disabled while the system is disarmed and the ignition switch is in the ON position
Available for light trucks
The P375B system is also available for light trucks which use a +24 Volts battery supply,
Dual Immobilisation Circuits
The system features two independent 30 Amp rated, normally open immobilisation circuits, which break engine critical signals in the vehicle. Starter motor, fuel pump, fuel injection, main ignition are commonly immobilised circuits
Safety circuitry in case of power failure System sources alternate power from ignition if main power is lost
Third circuit of immobilisation (optional) Additional immobilisation circuits can be added to conform with insurance company requirements.
Component protection against harsh road conditions
All relays are fully encapsulated to provide protection against dust and moisture
Rolling Code / Code Hopping
Rolling code encoder with over 18,000,000,000,000,000,000+ code combinations, transmitting via 433MHz PWM RF signal
Controller Type Uses two black ABS plastic remote controls with long life Lithium batteries
Large system memory Allows system to track three controllers
Controller re-programming Service technician can delete lost or stolen controllers from memory
Compatible Remotes This system comes standard with REM-111
Remote battery life Two CR2016 Lithium batteries have a expected average life span of between 9 and 18 months (depending on usage).
All cables extending from the control module are black and same diameter. Identifying wire tags are removed by the installer during installation of the system
Plug and play for service Designed to allow easy access for service technicians. Plugs and sockets are located inside the main control module to protect against access by thieves
Connector plug is enclosed within module case to prevent access by thief
Cutting any immobilisation wiring will still leave the car secure. Bypassing security is not possible by simply removing the system from the vehicle
Emergency Personal Identification Number (PIN) override
If the valid controller are lost, stolen or broken, the user by over-ride the system by enter the secret four digits via the ignition switch.
A factory programmed PIN comes standard with each system. It is recommended the owner of the system changes the PIN to a new, easily remembered number.
One shot override
Immobiliser always re-arms to protect vehicle. Re-enter PIN if vehicle needs to be driven after auto-arming has occurred
High security keys and lock Disable siren sound when vehicle is taken in for service
A record of the factory programmed override PIN is supplied on handy wallet sized card
Super bright red dash LED This LED flashes to inform user when system is armed. The LED is mounted on the driver's side dash and is visible from outside the window
System flashes car indicators when arming or disarming
System flashes car indicators when thief triggers alarm
Mini battery backup siren
Siren sounds even if battery terminals are disconnected from vehicle battery
Negative siren output, Can be used to trigger car horn relay or siren
Arm/Disarm confirmation System sounds a siren when arming and disarming.
Temporary arm/disarm chirp disable. Momentarily press the second button of the remote control before pressing the main button, the siren will not chirp during that one operation
Doors, bonnet and boot monitoring. Triggers alarm system if intruder opens any protected entry point in vehicle.
Audio glass breakage detection. Uses the sound of the breaking glass to trigger (not vibration) GBS-4XR..
Accepts plug-in Ultra-sonic sensor. Sensor produces a 40KHz sound wave and measures echo to detect intruder,ACC-001.
Accepts plug-in single zone microwave sensor. Sensor produces a microwave field to detect intruder, ACC-003.
Accepts plug-in dual zone microwave sensor. Sensor produces two microwave fields, exterior field to sound siren as warning, interior to trigger alarm in full, ACC-004.
Accepts plug-in single stage shock sensor. Sensor measures vibration subjected to vehicle to detect intruder,SEN-002.
Accepts plug-in two stage shock sensor. Sensor measures two levels of shock, soft shock to sound siren as warning, heavy shock to trigger alarm in full, SEN-006.
Compatible with tilt sensor. Sensor measures vehicle angle with respect to earth, triggers if angle changes - no response to vibration SEN-004.
Locks and unlocks all doors. System can trigger factory central locking, aftermarket central locking or central locking relays.
Variable pulse time. Extend pulse length to drive pneumatic central locking systems (Mercedes).
Automatic re-locking. System will re-arm and re-lock doors if previously disarmed by remote control and doors remain closed.
Anti-hijacking protection. System locks doors when ignition is turned on, unlocks when ignition is turned off.
Dual stage unlock. Allows user to unlock driver's door before unlocking all other doors.
Current draw. Wide Operating voltage. Operating voltage +9VDC to +15VDC
Operating temperature. -20 degrees to +85 degrees for equipment designed to be installed within vehicle cabin.
Operating temperature. -20 degrees to +105 degrees for equipment designed to be installed inside engine compartment
Polarity protection The system circuitry is design to protect itself against accidental battery polarity reversal. This can happen when replacing the vehicle battery
Independent indicator power fuse. System uses independent fuse to power indicators, ensures short circuit in indicator circuit does not affect system operation
Short circuit protection. The power supply wire to the system is protected against an internal fault within the system
Panic / Car Finder. Press and hold second button of remote control to cause siren to sound and indicators to flash
Electric window closer Provides signals used by electric window closers, system will close all electric windows when armed by remote control.
Courtesy light switch activation. System switches courtesy light on for 30 seconds or until ignition switch is turned on, when disarmed.
Electronic boot release Press and hold the secondary remote control button, while system is disarmed, to activate boot release output. The indicators will flash four time each time the boot release signal is sent.
Manufacturers warranty on Control module. Guarantees control module is free from manufacturing defects for 24 months from time of purchase
Manufacturers warranty on Sundry items Guarantees remote controls, siren and sundry items are free from manufacturing defects for 12 months from time of purchase.
Australian Standard for vehicle Immobilisers
Manufactured in ISO9001 facility. Built within world standard production facility
AS/NZS 4601 sundry standards of compliance (or parts thereof) AS1939 - Degrees of protection provided by enclosures for electrical equipment (IP Codes)
AS3300 - Approval and test specification - General requirements for household and similar electrical appliances
AS/NZS3548 Limits and methods of measurement of radio disturbance characteristics of information technology equipment
AS/NZS3749 - Intruder alarm systems - Road vehicles
AS/NZS4268 - Radio equipment and systems - Short range devices
AS/NZS61000 - Electromagnetic compatibility (EMC)
NZS6300 - Approval and test specification - General requirements for household and similar electrical appliances
ISO7637 - Road vehicles - Electrical disturbance by conduction and coupling
IEC61000 - Electromagnetic compatibility (EMC)
ASTM B117 - Standard practice for operating salt spray (fog) apparatus