Cyclops - KE-CLR-TX90 - Keyless Entry Kit

A$120.00
Shipped in 2-3 Working Days
SKU
KE-CLR-TX90

Cyclops - KE-CLR-TX90 - Keyless Entry Kit

KE-CLR-TX90 Keyless Entry System

Installation available for an extra $150
(Installation available in Adelaide only)
Please contact us on 08 8371 5121 to book a time.

KEYLESS ENTRY SYSTEM

Introduction

The system is designed to provide remote keyless entry to vehicles with standard central locking. The system can provide visual conformation of lock / unlock via the indicator hazard lights and by a red dash mounted warning LED

  • Proudly Australian
    Designed and engineered in Perth, Western Australia
Controllers
  • Rolling Code / Code Hopping
    Rolling code encoder with over 18,000,000,000,000,000,000+ code combinations, transmitting via 433MHz PWM RF signal
  • Controller Type
    Uses REM-090 remote controls
  • Large system memory
    Allows system to track five controllers
  • Controller re-programming
    Service technician can delete lost or stolen controllers from memory
Wiring
  • Plug and play for service
    Designed to allow easy access for service technicians. Plugs and sockets are located inside the main control module to protect against access by thieves
Visual Output
  • Super bright red dash LED
    This LED flashes to inform user when system is armed. The LED is mounted on the driver's side dash and is visible from outside the window
  • Arm/Disarm confirmation
    System flashes car indicators when arming or disarming
Central Locking
  • Locks and unlocks all doors
    System can trigger factory central locking, aftermarket central locking or central locking relays
  • Variable pulse time
    Extend pulse length to drive pneumatic central locking systems (Mercedes)
  • Automatic re-locking
    System will re-arm and re-lock doors if previously disarmed by remote control and doors remain closed
  • Anti-hijacking protection
    The system will lock the vehicle door two seconds after the ignition is switched on, providing the door remains closed. The system will then unlock the doors when the ignition switch is turned off
  • Dual stage unlock
    Allows user to unlock driver's door before unlocking all other doors
Specifications
  • Super low current draw
    <15mA average while locked (average of flashing LED), <10mA unlocked
  • Wide Operating voltage
    Operating voltage +9VDC to +15VDC
  • Operating temperature
    -20 degrees to +85 degrees for equipment designed to be installed within vehicle cabin
  • Polarity protection
    The system circuitry is design to protect itself against accidental battery polarity reversal. This can happen when replacing the vehicle battery
  • Trigger output is back EMF protected
    Clamping diode protects the output driver transistor(s) to stop damage from the super high voltages that occur when a relay coil is released
  • Short circuit protection
    The power supply wire to the system is protected against an internal fault within the system
  • Current rating
    All relays rated to carry 15amps continuous, connector 8amps continuous
Convenience Functions
  • Electronic boot release
    Press and hold the secondary remote control button to activate boot release output. The indicators will flash four time each time the boot release signal is sent (boot release precludes total closure)
  • Total Closure
    A 15 second pulse is output on the boot release wire if the small button on the remote is pressed within 15 seconds of locking the doors. A successful total closure operation is accompanied by four indicator flashes. This pulse may be used to trigger window closure module (total closure precludes boot release)
  • Perimeter illumination
    As an extra safety feature, the indicators of the vehicle can be made to light up for 25 seconds after the doors are unlocked. The indicators will extinguish immediately if the doors are opened
Printed Material
  • Installation and User Guide
    Generic instructions on how to fit the sensors and how they work.
Warranty
  • Manufacturers warranty on Control module
    Guarantees control module is free from manufacturing defects for 24 months from time of purchase 
  • Manufacturers warranty on Remote controls
    Guarantees remote controls are free from manufacturing defects for 12 months from time of purchase 
Standards Compliance
  • Manufactured in ISO9001 facility
    Built within world standard production facility
Write Your Own Review
You're reviewing:Cyclops - KE-CLR-TX90 - Keyless Entry Kit
SSL Certificate
Copyright © 2016 Ministry of Bass. All rights reserved.