Cyclops - 661 - Alarm System

$180.00
Shipped in 2-3 Working Days
SKU
661

Cyclops - 661 - Alarm System

Cyclops - 661 - Alarm System

Installation available for an extra $200
(Installation available in Adelaide only)
Please contact us on 08 8297 6612 to book a time

Introduction

This remote control alarm is operated by multi code remote control. Entry point protection of doors, boot and bonnet with a shock sensor. Audible warning is achieved via a standard 115dB siren, visually via the vehicle indicators and via a dash mounted high intensity red LED. The system may provide keyless entry and a source of immobilisation

Operation

•Arming procedure while ignition is off

The system will arm immediately if the main button of a valid remote control is momentarily pressed, the doors will lock and all security functions will become active 

•Disarming procedure

The system will disarm when the main button of a valid remote control is pressed

Immobilisation

•Immobilisation Circuit

The system features a 30 Amp rated, normally closed immobilisation circuit, which breaks engine critical signals in the vehicle. Starter motor, fuel pump, fuel injection, main ignition are commonly immobilised circuits

•Safety circuitry in case of power failure

System sources alternate power from ignition if main power is lost

•Component protection against harsh road conditions

All relays are fully encapsulated to provide protection against dust and moisture

Controllers

•System memory

Allows system to track two controllers

•Controller re-programming

Service technician can delete lost or stolen controllers from memory

Wiring

•Plug and play for service

Designed to allow easy access for service technicians. Plugs and sockets are located inside the main control module to protect against access by thieves

Override

•Emergency Personal Identification Number (PIN) override

Enter the secret two digits to override the immobiliser 

•Alterable PIN

A factory programmed PIN comes standard with each system. It is recommended the owner of the system changes the PIN to a new, easily remembered number 

Visual Output

•Super bright red dash LED

This LED flashes to inform user when system is armed. The LED is mounted on the driver's side dash and is visible from outside the window

•Arm/Disarm confirmation

System flashes car indicators when arming or disarming

•Alarm illumination

System flashes car indicators when thief triggers alarm

•Trigger diagnostics

System will flash indicators to report the last triggered circuit

Audio Output

•Standard siren

Uses standard two wire 115dB siren

•Arm/Disarm confirmation

System sounds a siren when arming and disarming 

•Temporary arm/disarm chirp disable

Momentarily press the second button of the remote control before pressing the main button, the siren will not chirp during that one operation

Intrusion Detection

•Doors, bonnet and boot monitoring

Triggers alarm system if intruder opens any protected entry point in vehicle 

•Accepts plug-in single stage shock sensor

Sensor measures vibration subjected to vehicle to detect intruder, SEN-002.

Central Locking

•Locks and unlocks all doors

System can trigger factory central locking, aftermarket central locking or central locking relays 

•Variable pulse time

Extend pulse length to drive pneumatic central locking systems (Mercedes) 

•Automatic re-locking

System will re-arm and re-lock doors if previously disarmed by remote control and doors remain closed  

•Anti-hijacking protection

System locks doors when ignition is turned on, unlocks when ignition is turned off  

Specifications

•Current draw

<10mA average while armed

<150mA disarm (and for no more than 39 seconds after ignition is switched off)

•Wide Operating voltage

Operating voltage +9VDC to +15VDC

•Operating temperature

-20 degrees to +85 degrees for equipment designed to be installed within vehicle cabin

•Operating temperature

-20 degrees to +105 degrees for equipment designed to be installed inside engine compartment

•Polarity protection

The system circuitry is design to protect itself against accidental battery polarity reversal. This can happen when replacing the vehicle battery

•Independent indicator power fuse

System uses independent fuse to power indicators, ensures short circuit in indicator circuit does not affect system operation

•Short circuit protection

The power supply wire to the system is protected against an internal fault within the system

Convenience Functions

•Panic / Car Finder

Press and hold second button of remote control to cause siren to sound and indicators to flash

•Electric window closer

Provides signals used by electric window closers, system will close all electric windows when armed by remote control 

•Electronic boot release

Press and hold the secondary remote control button to activate boot release output. The indicators will flash four time each time the boot release signal is sent 

Standards Compliance

 

•Manufactured in ISO9001 facility

Built within world standard production facility

Write Your Own Review
You're reviewing:Cyclops - 661 - Alarm System
SSL Certificate
Copyright © 2017 Ministry of Bass. All rights reserved.